Primary drying comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2026-05-12. Where a claim depends on a specific study, the study is described rather than over-claimed.
Lyophilization, also called freeze-drying, removes water from a frozen material by sublimation under reduced pressure. The process begins with freezing, which converts free water into ice and may also produce a glassy phase. Primary drying then lowers chamber pressure so ice sublimes directly to vapor without passing through a liquid stage. Secondary drying raises the temperature modestly to remove bound water. The result is a porous, dry solid that usually reconstitutes quickly. Each stage influences pore structure, residual moisture, and stability.
The physics of lyophilization depends on phase boundaries and heat and mass transfer. During primary drying, heat supplied to the product must equal the latent heat of sublimation, while water vapor moves through the drying cake to the condenser. If shelf temperature or pressure is set too high, the ice front can exceed the collapse temperature, causing meltback or pore collapse. If conditions are too cold, drying slows and costs rise. Formulation excipients, vial geometry, and freezing rate alter these limits.
Lyophilization is a dehydration technique in which a product is frozen and the solvent is removed under reduced pressure. The low pressure allows ice to sublimate directly into vapor without passing through a bulk liquid phase. This differs from conventional drying, where heat drives evaporation and can damage heat-sensitive structures. The process is used for biological materials, pharmaceutical formulations, and some foods. Its main advantage is preservation of porous structure and rapid reconstitution.
Freezing is the first stage and sets the ice structure that later becomes the pore network. The formulation is cooled below its freezing point, often with a controlled ramp, and solutes concentrate as ice forms. Primary drying then lowers chamber pressure and supplies heat to sublime the ice. The product temperature must stay below its collapse or eutectic temperature to prevent structural loss. Secondary drying raises the temperature modestly to remove bound water and achieve a low residual moisture.
| Property | Value | Notes |
|---|---|---|
| Common synonyms | Freeze-drying; lyophilisation; cryodesiccation | Regional spelling and historical terms. |
| Primary drying pressure | 0.05-0.5 mbar (5-50 Pa) | Kept below the triple point of water; product-specific. |
| Shelf temperature range | -40 to +40 °C | Freezing, primary, and secondary stages use different set points. |
| Cycle duration | 12-72 hours | Depends on fill volume, formulation, and equipment. |
| Condenser temperature | -50 to -80 °C | Must remain below the product's ice temperature. |
Lyophilization removes water from a frozen material by sublimation under reduced pressure. The process begins with freezing, which converts liquid water into ice and fixes the structure of the sample. After freezing, primary drying lowers pressure so ice changes directly to vapor without passing through a liquid phase. Secondary drying then removes bound water that remains after ice sublimation. The result is a dry, porous solid that often retains its original shape.
The low pressure used during drying allows water vapor to move from the ice surface to a cold condenser. Energy supplied as heat drives sublimation but must stay below the collapse temperature of the frozen matrix. If the product becomes too warm, the frozen structure may soften or melt, reducing pore formation and slowing drying. Formulations often include bulking agents, stabilizers, or buffers to support a rigid cake. The final moisture content depends on formulation, freezing rate, and the length of secondary drying.
Lyophilization, or freeze-drying, removes water from a material by freezing it and then lowering pressure so ice changes directly to vapor. The process relies on sublimation, the phase transition from solid to gas without an intervening liquid state. It is used for heat-sensitive materials that would degrade in conventional drying. The three stages are freezing, primary drying, and secondary drying, each with distinct temperature and pressure requirements. In practice, cycle design balances these variables.
Freezing determines ice crystal structure and pore size, which affect drying speed and product uniformity. Rapid freezing creates small crystals, while slow freezing creates larger crystals and often faster sublimation. During primary drying, chamber pressure is held below the vapor pressure of ice, and shelf temperature supplies heat for sublimation. The ice front recedes, leaving a porous matrix. Thermal limits such as collapse and eutectic temperatures set safe boundaries for formulation. These limits vary with solute composition and concentration.
=== Conservation === Preserved specimens provide essential taxonomic, geographical, and historical evidence for understanding changes in fungal diversity over time and for developing conservation strategies. As habitats are altered or lost, older fungarium specimens may become the only surviving material evidence that particular fungi once occurred in a region. Fungarium records are among the primary sources used in compiling checklists and red list assessments, where conservation priorities depend on evidence of occurrence across time and space. As of 2025, 1,000 fungal species were included on the IUCN Red List. Reliable identification of potentially threatened fungi often requires examining broad sets of specimens across habitats, regions, and growth stages rather than relying on type material alone.
In March 2017, Lilly acquired CoLucid Pharmaceuticals for $960 million, obtaining the late clinical-stage migraine therapy candidate lasmiditan. In August 2017, Lilly and Shionogi jointly licensed their product varespladib to Ophirex for Ophirex's novel snakebite treatment program. In May 2018, Lilly acquired Armo Biosciences for $1.6 billion, obtaining the white blood cell-boosting cancer treatment candidate pegilodecakin. Days later, the company announced it would acquire Aurora kinase A inhibitor developer AurKa Pharma, and control over the lead compound, AK-01, for up to $575 million. In January 2019, Lilly announced it would acquire Loxo Oncology for $235 per share, valuing the business at around $8 billion, which significantly expanded the business's oncology offerings. The deal gave Lilly Loxo's oral TRK inhibitor, Vitrakvi (Larotrectinib), LOXO-292, an oral proto-oncogene receptor tyrosine kinase rearranged during transfection (RET) inhibitor, LOXO-305, an oral Bruton's tyrosine kinase (BTK) inhibitor, and LOXO-195, a follow-on TRK inhibitor. In March 2019, the company completed the corporate spin-off of Elanco. In August 2019, Elanco acquired the Bayer animal health business for $7.6 billion. In January 2020, the company announced its acquisition of Dermira for $1.1 billion, gaining control of lebrikizumab, glycopyrronium cloth used in the treatment of hyperhidrosis, and other assets.
from its lipids. By comparison with synthetically produced fatty acids, they were able to determine the position of the cyclopropane ring and proposed the name 11,12-methyleneoctadecanoic acid, without specifying the stereoisomerism of the structure. Viewed from the cyclopropane ring, different substituents are present on two carbon atoms, resulting in cis-trans-isomerism (see figure). The substituents can be on the same side (cis) or on different sides (trans) of the ring bond. Hofmann et al. were initially unable to clarify which structure was actually present at the time of discovery. However, in 1954 they hypothesized that the cis isomer was present. This was confirmed by a Canadian research group in 2005. A clear description of the spatial arrangement of the substituents is possible with the help of the Cahn-Ingold-Prelog priority rules, according to which the absolute configuration of the molecule is given as 11R,12S. The derived name (11R,12S)-methylenoctadecanoic acid is commonly used, even if it does not correspond to the recommendations of the IUPAC nomenclature. For the systematic naming of lactobacillic acid, the absolute configuration is given from the cyclopropane ring, with a C6 substituent (hexyl group) and a C10 substituent containing the carboxy group (decanoic acid), thus giving 10-[(1R,2S)-2-hexylcyclopropyl]decanoic acid
Sources: en.wikipedia.org
== Original restaurant == The first In-N-Out restaurant that opened in 1948 was demolished when Interstate 10 (then US 60/US 70/US 99, the Ramona Freeway, now the San Bernardino Freeway) was built from downtown Los Angeles to the San Gabriel Valley. The freeway runs over the original location. A new restaurant was completed in 1954 near the original Baldwin Park, California, location. It was closed in November 2004 and demolished on April 16, 2011, despite discussions about using it as an In-N-Out museum chronicling the origins and history of the company. In-N-Out built a replacement restaurant on the other side of the freeway next to the original In-N-Out University (opened in 1984). A new In-N-Out University was built on the property. The university building houses the training department, which was moved from Irvine, California. In addition, the company restaurant was moved from In-N-Out's Baldwin Park headquarters to the new lot, which holds the restaurant and university, less than a thousand feet away. In 2014, a replica of the first In-N-Out was built in Baldwin Park.
== Publication == In July 2016, Hillbilly Elegy was popularized by an interview with Vance in The American Conservative. The volume of requests briefly disabled the website. Halfway through August, The New York Times wrote that the title had remained in the top ten Amazon bestsellers since the interview's publication. Vance has credited his Yale contract law professor Amy Chua as the "authorial godmother" of the book, as she persuaded him to write the memoir.
Gordon R. Ward, writing in the correspondence columns of the British Medical Journal, proposed the use of blood plasma as a substitute for whole blood and for transfusion purposes as early as 1918. At the onset of World War II, liquid plasma was used in Britain. A large project, known as "Blood for Britain", began in August 1940 to collect blood in New York City hospitals for the export of plasma to Britain. Following heavy casualties in the Battle of Dunkirk, the Blood Transfusion Association in New York City originated the campaign that was enlarged to the whole US by the Red Cross, and was called the National Blood Programme. At the time, American physician Edwin Cohn pioneered the process of blood fractionation. He worked out the techniques for isolating the serum albumin fraction of blood plasma, which is essential for maintaining the osmotic pressure in the blood vessels, preventing their collapse. A freeze-dried plasma package was developed by the Surgeons General of the Army and Navy, working with the National Research Council, which reduced breakage and made transportation, packaging, and storage much simpler.
Sources: en.wikipedia.org
=== Ancient Greek–16th century knowledge and vernacular === Concerning historical and modern perceptions of the clitoris, the clitoris and the penis were considered equivalent by some scholars for more than 2,500 years in all respects except their arrangement. Due to it being frequently omitted from, or misrepresented in, historical and contemporary anatomical texts, it was also subject to a continual cycle of male scholars claiming to have discovered it. The ancient Greeks, ancient Romans, and Greek and Roman generations up to and throughout the Renaissance, were aware that male and female sex organs are anatomically similar, but prominent anatomists such as Galen and Vesalius regarded the vagina as the structural equivalent of the penis, except for being inverted; Vesalius argued against the existence of the clitoris in normal women, and his anatomical model described how the penis corresponds with the vagina, without a role for the clitoris. Ancient Greek and Roman sexuality additionally designated penetration as "male-defined" sexuality. The term tribas, or tribade, was used to refer to a woman or intersex individual who actively penetrated another person (male or female) through the use of the clitoris or a dildo. As any sexual act was believed to require that one of the partners be "phallic" and that therefore sexual activity between women was impossible without this feature, mythology popularly associated lesbians with either having enlarged clitorises or as incapable of enjoying sexual activity without the substitution of a phallus.
== Packaging and ingredients == The size content of energy gels is commonly 1.2 oz (32g), with a range from 1 oz to 1.5 oz packets. The portable packaging is designed to facilitate uninterrupted training or performance conditions. Common ingredients include water, maltodextrin, fructose, and various micronutrients, preservatives, and flavor compounds or caffeine.
Turquoise may also pseudomorphously replace feldspar, apatite, other minerals, or even fossils. Odontolite is fossil bone or ivory that has historically been thought to have been altered by turquoise or similar phosphate minerals such as the iron phosphate vivianite. Intergrowth with other secondary copper minerals such as chrysocolla is also common. Turquoise is distinguished from chrysocolla, the only common mineral with similar properties, by its greater hardness. Turquoise forms a complete solid solution series with chalcosiderite, CuFe6(PO4)4(OH)8·4H2O, in which ferric iron replaces aluminium.
Sources: en.wikipedia.org
Simple drying usually removes water by evaporation from a liquid or solid, often with heat. Lyophilization first freezes the material and then removes ice by sublimation under vacuum. This avoids prolonged exposure to liquid water and high temperatures.
Reduced pressure lowers the boiling point of water and allows ice to sublime at temperatures below freezing. It also helps remove water vapor from the product toward the condenser. The exact pressure is chosen to stay below the triple point of water.
No. Materials with low solids content or high volatile solvents may form weak or collapsed cakes. Some proteins and cells require stabilizers to survive freezing and drying stresses. Feasibility depends on formulation and process design.
Yes, the terms are generally interchangeable. Lyophilization is more common in pharmaceutical and laboratory contexts, while freeze-drying appears widely in food science and general writing. Both describe removal of solvent by sublimation under vacuum after freezing.