The short version of Sublimation fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-08-28 and is reviewed periodically as new material appears.
A typical cycle begins with freezing, sometimes including an annealing step to control ice crystal size. Freezing conditions influence the pore network that later allows vapor escape. During primary drying, shelf temperature and chamber pressure are set so heat enters the product while its temperature stays below the collapse or eutectic point. Secondary drying then raises the shelf temperature to desorb bound water and lower residual moisture. Cycle design depends on formulation, fill volume, container type, and equipment capability.
The physics of lyophilization couples heat transfer, mass transfer, and phase behavior. Sublimation requires a vapor pressure difference between the ice front and the chamber, and the dried layer adds resistance to vapor flow. Amorphous formulations are characterized by a glass transition temperature of the maximally freeze-concentrated solute, often denoted Tg'. Crystalline bulking agents can provide structure, while amorphous excipients stabilize labile components. Open questions remain about spatial heterogeneity, edge effects, and how laboratory cycles scale to production.
Lyophilization is a dehydration process that removes water from a frozen material by sublimation under low pressure. The material is first frozen so that water becomes ice; then the surrounding pressure is lowered below the vapor pressure of ice. Heat is applied gently so ice changes directly to vapor without passing through a bulk liquid phase. The vapor is collected on a cold condenser, leaving a dry porous matrix. This process differs from simple evaporation because the material remains frozen during the main drying stage.
The process usually has three stages: freezing, primary drying, and secondary drying. Freezing sets the ice crystal structure and can determine pore size in the final cake. Primary drying removes free ice by sublimation at low pressure and low shelf temperature. Secondary drying removes bound water by raising the shelf temperature, although some water may remain as part of the solid. Cycle parameters depend on formulation, fill volume, vial type, and equipment performance.
The physical chemistry of freezing influences whether a formulation forms an amorphous glass or a crystalline solid. Amorphous systems can collapse if product temperature rises above the glass transition temperature of the freeze concentrate. Crystalline systems may show eutectic melting, where ice and solute melt together at a fixed temperature. Formulators add bulking agents, lyoprotectants, and buffers to preserve structure and biological activity. The optimum cycle keeps product temperature below critical thresholds during primary drying while allowing efficient sublimation.
| Property | Value | Notes |
|---|---|---|
| Physical state | Solid, porous cake or powder | Depends on formulation and container |
| Typical storage temperature | 2–25 °C, protected from moisture | Some materials require colder conditions |
| Solubility class | Usually readily soluble after reconstitution | Not an intrinsic chemical property |
| Common analytical method | Karl Fischer titration | Used for residual moisture |
| Common synonyms | Freeze-drying; lyophilisation | Lyophilisation is a spelling variant |
Lyophilization removes water from a frozen material by sublimation under reduced pressure. The process begins with freezing, which converts liquid water into ice and fixes the structure of the sample. After freezing, primary drying lowers pressure so ice changes directly to vapor without passing through a liquid phase. Secondary drying then removes bound water that remains after ice sublimation. The result is a dry, porous solid that often retains its original shape.
The low pressure used during drying allows water vapor to move from the ice surface to a cold condenser. Energy supplied as heat drives sublimation but must stay below the collapse temperature of the frozen matrix. If the product becomes too warm, the frozen structure may soften or melt, reducing pore formation and slowing drying. Formulations often include bulking agents, stabilizers, or buffers to support a rigid cake. The final moisture content depends on formulation, freezing rate, and the length of secondary drying.
Freeze-drying is distinct from simple evaporation and from spray drying. Evaporation removes water at temperatures above freezing, while spray drying rapidly dries droplets in a heated gas stream. Lyophilization avoids high temperatures, which can be useful for heat-sensitive materials such as proteins, vaccines, and some foods. The porous cake produced by sublimation dissolves or rehydrates more quickly than a dense dried mass. Not all materials tolerate freezing or the pH shifts that can occur as solutes concentrate during ice formation.
The physics of lyophilization depends on phase boundaries and heat and mass transfer. During primary drying, heat supplied to the product must equal the latent heat of sublimation, while water vapor moves through the drying cake to the condenser. If shelf temperature or pressure is set too high, the ice front can exceed the collapse temperature, causing meltback or pore collapse. If conditions are too cold, drying slows and costs rise. Formulation excipients, vial geometry, and freezing rate alter these limits.
Equipment for lyophilization includes a vacuum chamber, temperature-controlled shelves, a condenser, and a vacuum pump. A refrigeration system cools the shelves and condenser below the product's freezing point. Process monitoring often uses Pirani and capacitance manometers, thermocouples, and resistance sensors. Cycle development balances product quality with time and energy use. Some products are annealed during freezing to improve crystallization of bulking agents. Open questions remain about scaling cycles between laboratory, pilot, and production freeze-dryers.
=== Legal status === Datopotamab deruxtecan was approved for medical use in the United States in January 2025. In December 2024, the US Food and Drug Administration granted the application for datopotamab deruxtecan breakthrough therapy designation. In January 2025, the Committee for Medicinal Products for Human Use of the European Medicines Agency adopted a positive opinion, recommending the granting of a marketing authorization for the medicinal product Datroway, intended for the treatment of breast cancer. The applicant for this medicinal product is Daiichi Sankyo Europe GmbH. Datopotamab deruxtecan was authorized for medical use in the European Union in April 2025.
== External links == tRNA, the Adaptor Hypothesis and the Wobble Hypothesis Wobble base-pairing between codons and anticodons Genetic Code and Amino Acid Translation Information of Aminoacyl tRNA Synthetases Genomic tRNA Database
Pentagon Papers, Chapter 2 Archived 2011-08-06 at the Wayback Machine Vietnam: The Impossible War Fall, Bernard B. Street Without Joy: The French Debacle In Indochina ANAPI's official website (National Association of Former POWs in Indochina) Hanoi upon the army's return in victory (bicycles demystified) Viet Nam Portal Photos about the First War of Indochina (French Defense Archives) (ECPAD) (in French)
Sources: en.wikipedia.org
=== 1 April === Ukraine reported shooting down two of three Shahed drones. A power substation in Zaporizhzhia Oblast was damaged by a drone strike. Ukrainian border guards intercepted a Russian sabotage group trying to enter Sumy Oblast. Valeriy Chaika, a Russian-appointed official in Starobilsk, Luhansk Oblast was killed after a bomb exploded in his car. The Security Service of Ukraine (SBU) arrested a resident of Kharkiv on suspicion of spying for Russia and a businessman from Berdiansk on suspicion of selling construction material for Russian fortifications. It also charged RT chief editor Margarita Simonyan in absentia with promoting genocide, spreading propaganda, justifying the Russian invasion and encouraging the violation of Ukraine's territorial integrity.
(February 2, 2016), "Forensic Chemistry and Ambient Mass Spectrometry: A Perfect Couple Destined for a Happy Marriage?", Analytical Chemistry, 88 (5), American Chemical Society (ACS): 2515–2526, doi:10.1021/acs.analchem.5b02397, ISSN 0003-2700, PMID 26768158 Wu, Chunping; Dill, Allison L.; Eberlin, Livia S.; Cooks, R. Graham; Ifa, Demian R. (September 20, 2012), "Mass spectrometry imaging under ambient conditions", Mass Spectrometry Reviews, 32 (3), Wiley: 218–243, doi:10.1002/mas.21360, ISSN 0277-7037, PMC 3530640, PMID 22996621 Eberlin, Livia S.; Norton, Isaiah; Orringer, Daniel; Dunn, Ian F.; Liu, Xiaohui; Ide, Jennifer L.; Jarmusch, Alan K.; Ligon, Keith L.; Jolesz, Ferenc A.; Golby, Alexandra J.; Santagata, Sandro; Agar, Nathalie Y. R.; Cooks, R. Graham (January 8, 2013), "Ambient mass spectrometry for the intraoperative molecular diagnosis of human brain tumors", Proceedings of the National Academy of Sciences, 110 (5): 1611–1616, Bibcode:2013PNAS..110.1611E, doi:10.1073/pnas.1215687110, ISSN 0027-8424, PMC 3562800, PMID 23300285 Eberlin, Livia S.; Norton, Isaiah; Dill, Allison L.; Golby, Alexandra J.; Ligon, Keith L.; Santagata, Sandro; Cooks, R. Graham; Agar, Nathalie Y.R. (January 31, 2012), "Classifying Human Brain Tumors by Lipid Imaging with Mass Spectrometry", Cancer Research, 72 (3), American Association for Cancer Research (AACR): 645–654, doi:10.1158/0008-5472.can-11-2465, ISSN 0008-5472, PMC 3271168, PMID 22139378
Ethylestrenol, also known as 3-deketo-17α-ethyl-19-nortestosterone or as 17α-ethylestr-4-en-17β-ol, is a synthetic estrane steroid and a 17α-alkylated derivative of nandrolone (19-nortestosterone; 19-NT). It is specifically the 17α-ethyl and 3-deketo derivative of nandrolone as well as the 3-deketo derivative of norethandrolone (17α-ethyl-19-NT). Other related AAS include bolenol (3-deketo-17α-ethyl-19-nor-5-androstenediol), ethyldienolone (17α-ethyl-δ9-19-NT), norboletone (17α-ethyl-18-methyl-19-NT), propetandrol (17α-ethyl-19-NT 3β-propionate), and tetrahydrogestrinone (THG; 17α-ethyl-18-methyl-δ9,11-19-NT). The progestins allylestrenol (3-deketo-17α-allyl-19-NT) and lynestrenol (3-deketo-17α-ethynyl-19-NT) are also closely related to ethylestrenol, differing only by the C17α substitution.
Sources: en.wikipedia.org
== Biochemistry == Ricin is classified as a type 2 ribosome-inactivating protein (RIP)[N.B]. Whereas type 1 RIPs are composed of a single protein chain that possesses catalytic activity, type 2 RIPs, also known as holotoxins, are composed of two different protein chains that form a heterodimeric complex. Type 2 RIPs consist of an A chain that is functionally equivalent to a type 1 RIP, covalently connected by a single disulfide bond to a B chain that is catalytically inactive, but serves to mediate transport of the A-B protein complex from the cell surface, via vesicle carriers, to the lumen of the endoplasmic reticulum (ER). Both type 1 and type 2 RIPs are functionally active against ribosomes in vitro; however, only type 2 RIPs display cytotoxicity due to the lectin-like properties of the B chain. To display its ribosome-inactivating function, the ricin disulfide bond must be reductively cleaved.
Growth hormone therapy refers to the use of growth hormone (GH) as a prescription medication—it is one form of hormone therapy. Growth hormone is a peptide hormone secreted by the pituitary gland that stimulates growth and cell reproduction. In the past, growth hormone was extracted from human pituitary glands. Growth hormone is now produced by recombinant DNA technology and is prescribed for a variety of reasons. GH therapy has been a focus of social and ethical controversies for 50 years. This article describes the history of GH treatment and the current uses and risks arising from GH use. Other articles describe GH physiology, diseases of GH excess (acromegaly and pituitary gigantism), deficiency, the recent phenomenon of HGH controversies, growth hormone in sports, and growth hormone for cows.
The Partido Comunista de España (Reconstituido) (English: "Communist Party of Spain (Reconstituted)", PCE(r)) is a Spanish clandestine Marxist-Leninist party that broke away from the Communist Party of Spain (PCE). The general secretary of the PCE(r) is Manuel Pérez Martínez ('Comrade Arenas') who was in prison from 2000 to March 2025 for terrorist activities.
If RA is adequate, T helper cell subtype Th1 is suppressed and subtypes Th2, Th17 and iTreg (for regulatory) are induced. Dendritic cells located in intestinal tissue have enzymes that convert retinal to all-trans-retinoic acid, to be taken up by retinoic acid receptors on lymphocytes. The process triggers gene expression that leads to T cell types Th2, Th17 and iTreg moving to and taking up residence in mesenteric lymph nodes and Peyer's patches, respectively outside and on the inner wall of the small intestine. The net effect is a down-regulation of immune activity, seen as tolerance of food allergens, and tolerance of resident bacteria and other organisms in the microbiome of the large intestine. In a vitamin A deficient state, innate immunity is compromised and pro-inflammatory Th1 cells predominate.
Sources: en.wikipedia.org
Freezing only converts liquid to solid. Lyophilization adds vacuum and controlled warming so frozen solvent sublimes, leaving a dry porous solid. The two steps are related but not interchangeable.
Reduced pressure keeps the solvent below its triple point, allowing ice to become vapor without melting. Vacuum also helps remove water vapor from the product chamber. The exact pressure is chosen with the formulation and equipment.
Residual moisture is water that remains in the dried solid after secondary drying. It is often measured by Karl Fischer titration, near-infrared spectroscopy, or thermogravimetry. Acceptable levels depend on the material and its stability profile.
The main change is sublimation, in which ice becomes water vapor without melting into liquid water. This occurs when the chamber pressure is held below the vapor pressure of ice while mild heat is supplied. The result is a dry, porous solid that retains much of its original shape.