The short version of secondary drying fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2025-09-09. Anything still debated is marked as such rather than presented as settled.
After primary drying, secondary drying removes water that remains bound to the material. This stage raises the shelf temperature while maintaining low pressure, which encourages desorption of unfrozen water. Residual moisture can be reduced to a low percentage, improving stability for many products. The process parameters, including freezing rate, shelf temperature, and chamber pressure, influence the final pore structure and reconstitution behavior. Control of these variables helps prevent collapse or meltback during drying.
A formulation often contains excipients that protect the active ingredient during freezing and drying. Bulking agents provide structure, while lyoprotectants stabilize sensitive molecules. The freezing step can produce ice crystals whose size and distribution affect the drying rate, and cycle design includes freezing, annealing, and drying phases. If the product temperature rises above a critical value, the cake may collapse or lose its porous structure. Successful lyophilization therefore depends on the interaction between formulation, equipment, and cycle design.
Freeze-drying is used for materials whose activity or structure depends on low temperature and low water content. Examples include certain biologics, diagnostic reagents, starter cultures, coffee, and porous inorganic precursors. The dried product forms a cake whose porosity aids rapid wetting and dissolution. Main drawbacks are high energy use, long cycle times, and sensitivity to formulation and equipment variation. Questions remain about how freezing rates and ice morphology affect batch uniformity, especially when moving from laboratory to production scale.
Lyophilization, also called freeze-drying, is a dehydration process in which a solvent, usually water, is frozen and then removed by sublimation under reduced pressure. The method preserves heat-sensitive materials that would degrade in conventional drying. Large-scale use grew during the mid-twentieth century for blood plasma and antibiotics, and it later expanded to vaccines, enzymes, foods, and advanced materials. The process produces a dry, porous solid that usually reconstitutes rapidly. It is distinct from simple evaporation because the solvent bypasses the liquid phase during primary removal.
The process generally proceeds in three stages: freezing, primary drying, and secondary drying. During freezing, controlled cooling converts water into ice and may also crystallize or vitrify solutes. In primary drying, the pressure is lowered below the triple point, and heat is supplied so ice sublimes directly to vapor. Secondary drying removes water that remains bound to the solid matrix, yielding a low final water content. Product temperature must stay below the collapse or glass transition temperature to maintain structure. Cycle design therefore balances shelf temperature, chamber pressure, and time.
| Property | Value | Notes |
|---|---|---|
| Common synonyms | Freeze-drying, lyophilisation | Lyophilization is the American spelling; lyophilisation is British |
| Primary drying mechanism | Sublimation of ice | Occurs under vacuum below the triple point |
| Typical chamber pressure | 0.05-0.5 mbar | Range depends on product and equipment |
| Typical shelf temperature during freezing | -40 to -20 °C | Lower temperatures may be used for labile products |
| Resulting product form | Porous cake or powder | Appearance depends on formulation and cycle |
The process usually has three stages: freezing, primary drying, and secondary drying. Freezing sets the ice crystal structure and can determine pore size in the final cake. Primary drying removes free ice by sublimation at low pressure and low shelf temperature. Secondary drying removes bound water by raising the shelf temperature, although some water may remain as part of the solid. Cycle parameters depend on formulation, fill volume, vial type, and equipment performance.
The physical chemistry of freezing influences whether a formulation forms an amorphous glass or a crystalline solid. Amorphous systems can collapse if product temperature rises above the glass transition temperature of the freeze concentrate. Crystalline systems may show eutectic melting, where ice and solute melt together at a fixed temperature. Formulators add bulking agents, lyoprotectants, and buffers to preserve structure and biological activity. The optimum cycle keeps product temperature below critical thresholds during primary drying while allowing efficient sublimation.
Lyophilization is a dehydration technique in which a product is frozen and the solvent is removed under reduced pressure. The low pressure allows ice to sublimate directly into vapor without passing through a bulk liquid phase. This differs from conventional drying, where heat drives evaporation and can damage heat-sensitive structures. The process is used for biological materials, pharmaceutical formulations, and some foods. Its main advantage is preservation of porous structure and rapid reconstitution.
Freezing is the first stage and sets the ice structure that later becomes the pore network. The formulation is cooled below its freezing point, often with a controlled ramp, and solutes concentrate as ice forms. Primary drying then lowers chamber pressure and supplies heat to sublime the ice. The product temperature must stay below its collapse or eutectic temperature to prevent structural loss. Secondary drying raises the temperature modestly to remove bound water and achieve a low residual moisture.
In Hydra, different types of nematocysts are distinguished: the desmonemes for prey attachment; the isorhizas with spines in the interior of the nematocyst capsule and the spineless atrichous isorhizas; and the large stenoteles, with a prominent stylet apparatus at the tubule base employed for piercing cuticle structures. Hydra has two main body layers, which makes it diploblastic. The layers are separated by mesoglea, a gel-like substance. The outer layer is the epidermis, and the inner layer is called the gastrodermis, because it lines the stomach. The cells making up these two body layers are relatively simple. Hydramacin is a bactericide recently discovered in Hydra; it protects the outer layer against infection. A single Hydra is composed of 50,000 to 100,000 cells which consist of three specific stem cell populations that create many different cell types. These stem cells continually renew themselves in the body column. Hydras have two significant structures on their body: the "head" and the "foot". When a Hydra is cut in half, each half regenerates and forms into a small Hydra; the "head" regenerates a "foot" and the "foot" regenerates a "head". If the Hydra is sliced into many segments then the middle slices form both a "head" and a "foot". Respiration and excretion occur by diffusion throughout the surface of the epidermis, while larger excreta are discharged through the mouth by a quick radial contraction of the body column.
Between 30 and 40 percent of people undergoing chemotherapy experience chemotherapy-induced peripheral neuropathy (CIPN), a progressive, enduring, and often irreversible condition, causing pain, tingling, numbness and sensitivity to cold, beginning in the hands and feet and sometimes progressing to the arms and legs. Chemotherapy drugs associated with CIPN include thalidomide, epothilones, vinca alkaloids, taxanes, proteasome inhibitors, and the platinum-based drugs. Whether CIPN arises, and to what degree, is determined by the choice of drug, duration of use, the total amount consumed and whether the person already has peripheral neuropathy. Though the symptoms are mainly sensory, in some cases motor nerves and the autonomic nervous system are affected. CIPN often follows the first chemotherapy dose and increases in severity as treatment continues, but this progression usually levels off at completion of treatment. The platinum-based drugs are the exception; with these drugs, sensation may continue to deteriorate for several months after the end of treatment. Some CIPN appears to be irreversible. Pain can often be managed with drug or other treatment but the numbness is usually resistant to treatment.
While the +4 and the −3 positions in the Kozak sequence have the greatest relative importance in the establishing a favorable initiation context a CC or AA motif at −2 and −1 were found to be important in the initiation of translation in tobacco and maize plants. Protein synthesis in yeast was found to be highly affected by composition of the Kozak sequence in yeast, with adenine enrichment resulting in higher levels of gene expression. A suboptimal Kozak sequence can allow for the pre-initiation complex (PIC) to scan past the first AUG site and start initiation at a downstream AUG codon.
Duloxetine and milnacipran are also contraindicated in patients with uncontrolled narrow-angle glaucoma, as they have been shown to increase incidence of mydriasis. SNRIs should not be used to treat depressive episodes in bipolar I disorder and should only be used to treat depression in bipolar II disorder with caution and accompanied by mood stabilizers to avoid hypomania.
From 1967 to 1993, almost all paclitaxel produced was derived from bark of the Pacific yew, Taxus brevifolia, the harvesting of which kills the tree in the process. The processes used were descendants of the original isolation method of Monroe Wall and Mansukh Wani; by 1987, the U.S. National Cancer Institute (NCI) had contracted Hauser Chemical Research of Boulder, Colorado, to handle bark on the scale needed for phase II and III trials. While both the size of the wild population of the Pacific yew and the magnitude of the eventual demand for paclitaxel were uncertain, it was clear that an alternative, sustainable source of the natural product would be needed. Initial attempts to broaden its sourcing used needles from the tree, or material from other related Taxus species, including cultivated ones, but these attempts were challenged by the relatively low and often highly variable yields obtained. Early in the 1990s, coincident with increased sensitivity to the ecology of the forests of the Pacific Northwest, paclitaxel was extracted on a clinically useful scale from these sources.
Sources: en.wikipedia.org
The rapid expansion of AI infrastructure has significant environmental implications. The energy demands of data centres are projected to grow substantially, potentially conflicting with the UK's net-zero targets and straining grid capacity. Additionally, the water consumption required for cooling data centres has raised sustainability concerns. Beyond domestic impacts, the global AI supply chain relies heavily on the extraction of critical minerals (such as cobalt and lithium) in the Global South, often associated with environmental degradation and human rights abuses. The development of AI models also depends on low-wage "ghost workers" in developing nations for data annotation and content moderation, prompting calls for mandatory human rights due diligence laws. While economic forecasts suggest AI could significantly boost UK GDP and productivity, realising these gains faces a "productivity paradox". Despite experimental evidence of productivity improvements, economy-wide data does not yet reflect an AI-driven boost, largely due to low adoption rates of bespoke systems among traditional businesses and the concentration of economic value among a small percentage of organisations. Furthermore, economists warn of "algorithmic rents", where dominant tech platforms extract wealth, potentially eroding the UK tax base and exacerbating market concentration. The UK's Digital Services Tax (DST) attempts to address this but remains controversial with the US government.
In the early stages after the procedure, the use of interdental brushes is strongly advised against due to the potential damage to interdental tissues in the operated area, toothpicks are recommended as an alternative. The patient is asked to visit every two weeks for monitoring of their plaque levels. The time between visits will gradually increase if the patients’ plaque control is up to standard.
==== Silver ion tablets ==== An alternative to iodine-based preparations in some usage scenarios are silver ion/chlorine dioxide-based tablets or droplets. These solutions may disinfect water more effectively than iodine-based techniques while leaving hardly any noticeable taste in the water in some usage scenarios. Silver ion/chlorine dioxide-based disinfecting agents will kill Cryptosporidium and Giardia, if utilized correctly. The primary disadvantage of silver ion/chlorine dioxide-based techniques is the long purification times (generally 30 minutes to 4 hours, depending on the formulation used). Another concern is the possible deposition and accumulation of silver compounds in various body tissues leading to a rare condition called argyria that results in a permanent, disfiguring, bluish-gray pigmentation of the skin, eyes, and mucous membranes.
In particular, the Osedax worm lacks specific gene families involved in bone lipid and carbohydrate metabolism. This function is complemented by the Oceanospirillales symbionts, which utilize the glyoxylate cycle to catabolize nutrients from whale bones and convert fatty acids into carbohydrates. The Osedax are then able to take up and store the end products as glycogen. Bacteriocytes are present in the Osedax lower trunk subepidermal connective tissue, and there are additional genes in the bacteriocytes that encode amino acids and glucose and aid in digestion and absorption of proteins into the roots.
Sources: en.wikipedia.org
The hypothalamus is commonly known as an integration center of the brain because of its role in integrating inputs from all areas of the brain and producing a specific response. In the neuroendocrine system, the hypothalamus receives electrical signals from different parts of the brain and translates those electrical signals into chemical signals in the form of hormones or releasing factors. These chemicals are then transported to the pituitary gland and from there to the systemic circulation.
=== Chemical-pharmaceutical industry and laboratories === Acetonitrile is used as a solvent, particularly in the pharmaceutical industry. According to a market analysis, approximately 180,000 tons of acetonitrile were produced worldwide in 2022, of which around 70% was consumed by the pharmaceutical sector. It is also one of the most important solvents for analyses performed by high-performance liquid chromatography. The thermal decomposition of azobisisobutyronitrile (AIBN) and related compounds (e.g., azobis(cyclohexanecarbonitrile)) generates relatively stable radicals; accordingly, these compounds are used as radical initiators in radical reactions, particularly polymerizations. The quinone DDQ, which contains two nitrile groups, is a widely used oxidizing agent, including in pharmaceutical synthesis. Nitrile groups can be incorporated into biomolecules as probes for infrared spectroscopic investigations. Some nitriles serve as starting materials for the synthesis of pharmaceuticals. Ketoprofen is an anti-inflammatory agent approved in some EU countries; propionitrile is used in its industrial synthesis.
As enologists began better understanding the science of fermentation, nitrogen was identified as a principal nutrient and winemakers as early as the 1900s began adding ammonium salts to their must. Urea was also used as an early nitrogen supplement but research linking it to the development of ethyl carbamate has led to its banning in many countries, including the United States since 1990. There are many types of nitrogen supplements available for winemakers to use. Most of them are complex formulations that include nitrogen (from either amino acids or ammonium salts) along with vitamins, minerals and other growth factors and sold under brand names like Go-Ferm, Superfood, Fermaid K (the later two also containing some DAP). Amino acids can be added directly to the must though as of 2010 only glycine is permitted to be added to must in the United States.
Sources: en.wikipedia.org
Lyophilization removes water by sublimation from a frozen material, while evaporation changes liquid water into vapor. The low-pressure freezing step avoids the liquid phase and can preserve heat-sensitive structures.
Vacuum lowers the pressure below the triple point of water, allowing ice to sublimate directly into vapor. It also helps remove water vapor from the product chamber and shortens primary drying.
Many aqueous solutions and suspensions can be freeze-dried, but some formulations collapse or do not form a stable cake. The process requires careful formulation and cycle development.
Yes. Lyophilization and freeze-drying are synonyms for the same vacuum-assisted sublimation process. The term lyophilization is more common in pharmaceutical and laboratory settings, while freeze-drying is widely used in food and general contexts.